Mind-Numbing Equity

There's no term for the "equity" that we put into our house this weekend. We made up a new one: Mind-Numbing Equity. Neither of us worked up much of a sweat but we did spend hours at the same tedious tasks. With the framing near complete, we had to open up the basement floor to allow a post to be set to support some flooring joists below the bathrooms. Justin did all of the work here save for marking the concrete with the location.

Here's our 1 foot deep hole for the post.

While he was at it, Justin busted out the last of the bricks from the chimney so he'd have it ready when it is time to pour concrete patches.

Here are the remnants of what I was doing while Justin shoveled out the basement: staples from the carpet pad installation. There are about 600 million of these in the wood floors and stairs and they all have to come out before the floor can be refinished. I pulled them all out of the stairs this weekend.

Our other big task this weekend was to deal with the flooring. We know that there are wood floors throughout the house. Most of the house is fir flooring except for the dining and living which is oak. The oak flooring is in questionable shape and to date, we've been operating under the idea that the oak needs to be replaced because it can't be sanded down and refinished. The thickness isn't there--maybe we have 1/4"-3/8" with which to work. The fir on the other hand is 3/4" tongue and groove and is in pretty good condition--nothing a good refinishing can't fix. There are several places that will need to be patched due to moving heat registers, a missing chimney and a few walls in new places. In the downstairs hallway, kitchen and a little spot upstairs there is (was) glue-down vinyl/linoleum flooring. In the hallway, the flooring came up beautifully once we applied the heat gun to it. You can see the photo below where it looks nearly brand new. In the kitchen and upstairs though, it's another story. The vinyl is really stuck. We bought some sanding/brushing attachments for the angle grinder to try and remove the glue and paper backing from the flooring. Our method works but it is slow going. We're not sure what we're going to do for the kitchen which is approximately 200 square feet and will take a lot of time.

Here's a photo of the hallway minus the glue-down flooring.

This is the little nook upstairs that we carved out from the former bathroom that is now part of the hallway and might become a little desk area in the future. The lighter patch of wood on the right is the area that we used the grinder on. This area is about 5 square feet and maybe took us a half hour to remove the glue.This is the kitchen floor, just a little corner that we scraped the top part of the vinyl flooring from. The white stuff left is the paper backing and there is a really tacky, gummy glue under that.